STEICOmulti connect

  • The adherent surfaces must be capable of bearing a load, clean as well as free from grease, oil and dust. Any existing separating agents must be removed
  • A precheck for compatibility is required when used on coated substrates
  • Apply 6–8 mm thick beads on one-side on the sheet/membrane or the load-bearing construction material
  • Fix the sheet/membrane in place using the relief loop within the wet phase of the adhesive bead by using light pressure (ATTENTION: Do not press bead flat)
  • Adhesive bonding can alternatively take place after a partial drying (16–20 h, in a dust-free environment) in the dry adhesive bead. The pressure can be increased in this case

Product overview

or choose combination

Area of application
Product group
© 2021 STEICO SE